ThisCalculator

Everyday

Root Cricket ZTE Score X500 with One Click Tool

Updated · Standard formula, shown below

Root Cricket ZTE Score X500 with One Click Tool

This guide walks you through rooting the Cricket ZTE Score X500 using a one-click tool, giving you superuser access to remove bloatware, install custom ROMs, and tweak system settings. Before starting, you must enable USB debugging and OEM unlocking on your device, and ensure your battery is above 70%.

What You’ll Need

  • A Windows PC (Windows 7 or newer)
  • A USB data cable for your ZTE Score X500
  • ZTE USB drivers installed on your PC (download from ZTE’s official support page)
  • The one-click rooting tool: KingoRoot (Windows version) or similar
  • Backup of your important data (rooting may wipe your device)

Step-by-Step

  1. Enable Developer Options: Go to Settings > About phone and tap Build number seven times until you see a message that developer mode is enabled.
  2. Enable USB Debugging and OEM Unlocking: Go to Settings > Developer options and toggle on USB debugging and OEM unlocking (if available).
  3. Install ZTE USB Drivers: Download and install the official ZTE USB drivers on your PC. Reboot your PC after installation.
  4. Download and Install KingoRoot: Download the KingoRoot Windows client from the official website and install it on your PC.
  5. Connect Your Phone: Connect your ZTE Score X500 to your PC using the USB cable. When prompted on your phone, allow USB debugging by tapping OK.
  6. Wait for Driver Recognition: The KingoRoot software should detect your device. If it doesn’t, try a different USB port or reinstall the drivers.
  7. Start Rooting: Click the Root button in KingoRoot. The software will begin the rooting process, which may take a few minutes. Do not disconnect your phone during this time.
  8. Wait for Success Message: Once the process completes, you’ll see a message saying “Root succeeded.” Your phone will reboot automatically.
  9. Verify Root: After reboot, install a root checker app from the Play Store to confirm root access. If it says “Root access is properly installed,” you’re done.

Common Mistakes

  • Not enabling USB debugging: Without this, the PC cannot communicate properly with your phone, and the tool will fail.
  • Using a faulty USB cable: Some cables only charge and don’t transfer data. Use the original cable or a known good one.
  • Interrupting the process: Unplugging the phone or closing the tool mid-root can brick your device. Be patient.
  • Battery too low: If the phone dies during rooting, it can cause permanent damage. Always charge above 70%.
  • Skipping driver installation: Without proper drivers, the tool won’t recognize your device, and you’ll get an error.

Tips

  • Back up your phone before rooting. Use the built-in backup or a third-party app.
  • Rooting voids your warranty. Consider this before proceeding.
  • After rooting, you can uninstall bloatware using apps like Titanium Backup (requires root).
  • Keep a copy of the stock ROM in case you need to unroot or restore your device.
  • If the one-click tool fails, try an alternative like SuperSU or Magisk, but note that these may require manual steps.

Troubleshooting

Phone not detected by KingoRoot: Reinstall the ZTE USB drivers, try a different USB port, and ensure USB debugging is enabled. Also, check that the phone is in “File Transfer” mode (not just charging).

Root fails with “Device not supported”: This tool may not support your specific firmware version. Try updating your phone to the latest firmware, or use a different one-click tool like iRoot or KingRoot (Android app).

Phone stuck in boot loop after rooting: Boot into recovery mode (usually Volume Up + Power) and perform a factory reset. If that doesn’t work, flash the stock ROM using the manufacturer’s flashing tool.

Root checker says no root: The process may have silently failed. Try re-running the tool, or manually install a root manager like SuperSU from the Play Store and update the binary.

USB debugging keeps turning off: Some phones disable it after a while. Re-enable it and keep the screen on during the process.

Frequently Asked Questions

Will rooting my ZTE Score X500 delete my data?

Typically, one-click tools do not wipe data, but there’s always a risk. Always back up your data before rooting.

Can I unroot after rooting?

Yes, most one-click tools have an “Unroot” option. You can also use the stock ROM to restore your device to factory state.

Is rooting legal?

Rooting is generally legal in most countries, but it voids your warranty. Check your local laws regarding device modification.

Will I still receive OTA updates after rooting?

Usually not, because rooting modifies the system partition. You may need to unroot to receive updates, or manually flash updates.

What is the risk of bricking my phone?

With a one-click tool, the risk is low but not zero. Following the steps carefully and not interrupting the process minimizes the risk.

Can I root without a PC?

Yes, some Android apps like KingRoot can root without a PC, but they are less reliable and may contain malware. The PC method is safer.

Related

Method: the standard formula for this calculation, rounded as each result states. See how the calculators work or report an error.