Ant Empire Codes: Active Redeem List & How to Use

Ant Empire codes are short alphanumeric strings that you redeem in the game for free resources like honey, leaves, and speed-ups. To use them, open the game, tap your profile icon, find the “Redeem Code� or “Gift Code� field, enter the code exactly as shown, and confirm. Below is a list of currently active codes, plus instructions on where to find new ones and how to avoid common mistakes.

Formula

The calculator on this page works out your average pace and speed from the time you took to finish a run or ride and the distance you covered. The formulas are:

• Pace (min/km) = Finish time (min) ÷ Distance (km)
• Speed (km/h) = Distance (km) ÷ (Finish time (min) ÷ 60)

Where:

• Finish time (t) – the total time from start to finish, in minutes.
• Distance (d) – the length of the route, in kilometres.
• Pace – the number of minutes it takes to cover one kilometre.
• Speed – the number of kilometres you cover in one hour.

Worked Example

Using the default values from the calculator block (50 minutes for 10 km):

1. Pace = 50 ÷ 10 = 5.0 min/km
2. Speed = 10 ÷ (50 ÷ 60) = 10 ÷ 0.8333 = 12.0 km/h

So a 50-minute, 10 km run gives an average pace of 5:00 per kilometre and an average speed of 12.0 km/h.

How to Read the Result

Lower pace numbers mean faster running – 4:30 min/km is quicker than 6:00 min/km. Speed works the opposite way: higher km/h is faster. For cycling, typical recreational speeds range from 15 to 25 km/h, while running paces often fall between 5 and 8 min/km. The calculator gives you a single average, so it won’t show hills, stops, or changes in effort – it’s a simple overall figure.

Common Mistakes

• Using seconds instead of minutes – always convert your time to minutes first.
• Mixing miles and kilometres – if your distance is in miles, multiply by 1.60934 to get kilometres.
• Confusing pace and speed – pace is time per distance, speed is distance per time.
• Rounding too early – keep extra decimal places during the calculation, then round at the end.

When to Use This Calculator

Use it after a training run, a commute, or a race to get a quick average. It’s also handy for planning: if you want to finish a 10 km race in 50 minutes, you know you need to hold a 5:00 min/km pace. For interval training, you might calculate pace for each repetition separately rather than the whole session.

Limitations of the Formula

The formula assumes constant speed and a flat route. Real-world factors like wind, elevation gain, and surface type will make your actual effort vary. The calculator also ignores heart rate, power output, and splits, so it’s not a substitute for a GPS watch or training software. It’s best used as a quick reference, not a precise performance metric.

Frequently Asked Questions

How do I convert my pace from min/km to min/mile?

Multiply the pace in min/km by 1.60934. For example, 5:00 min/km becomes 8:03 min/mile. To convert the other way, divide by 1.60934.

What’s the difference between pace and speed?

Pace is the time it takes to cover a fixed distance (e.g., 5 minutes per kilometre). Speed is the distance covered in a fixed time (e.g., 12 km per hour). Runners usually talk about pace, while cyclists and drivers use speed.

Can I use this for walking?

Yes. A typical walking pace is 10–12 min/km, which works out to 5–6 km/h. Enter your walking time and distance to get your average.

Why does my GPS watch show a different pace?

GPS watches calculate pace in real-time, often using moving time rather than elapsed time, and they may account for elevation gain. This calculator uses total time and total distance, so it’s a simple average that won’t match every device.

How do I calculate pace for a marathon?

A marathon is 42.195 km. If you want to finish in 4 hours (240 minutes), divide 240 by 42.195 to get about 5:41 min/km. Use the calculator with time in minutes and distance in km.

Related

• Restore Deleted Messages Icon on iPhone Home Screen
• 5 Story-Driven Games Like Life Is Strange
• Mini LED vs OLED for Gaming: HDR, Response, Burn-In

in t | Finish time | min | 50 | 0
in d | Distance | km | 10 | 0
out pace | Average pace | min/km | t / d | 2
out speed | Average speed | km/h | d / (t / 60) | 2